Investigation into the impact of integral suppressor configurations on the pressure levels within the suppressor

This paper reports on an experimental investigation supported by basic modeling in to the performance of an integral suppressor on a low power firearm. A model was developed to determine the pressure within a suppressor chamber using iterative empirical calculations of the gas properties and flow within the system. The design of a reconfigurable suppressor chamber has been undertaken allowing suppressor chamber volume to be varied through the use of baffles. Pressure transducers were used to determine the pressure within the suppressor chamber for a series of firings. The results of the firings with different configurations within the suppressor are presented allowing trends to be established. The modeling and experimental results show an increase in suppressor chamber volume results in a reduction of recorded pressure within the suppressor chamber

A ratio model of perceived speed in the human visual system

The perceived speed of moving images changes over time. Prolonged viewing of a pattern (adaptation) leads to an exponential decrease in its perceived speed. Similarly, responses of neurones tuned to motion reduce exponentially over time. It is tempting to link these phenomena. However, under certain conditions, perceived speed increases after adaptation and the time course of these perceptual effects varies widely. We propose a model that comprises two temporally tuned mechanisms whose sensitivities reduce exponentially over time. Perceived speed is taken as the ratio of these filters' outputs. The model captures increases and decreases in perceived speed following adaptation and describes our data well with just four free parameters. Whilst the model captures perceptual time courses that vary widely, parameter estimates for the time constants of the underlying filters are in good agreement with estimates of the time course of adaptation of direction selective neurones in the mammalian visual system

Comparison of porcine thorax to gelatine blocks for wound

Published online first in International Journal of Legal Medicine. The support of EPSRC and The Home Office are recognised. Open Access, this article is distributed under the terms of the Creative Commons Attribution 4.0 International License (http:/ /creativecommons.org/licenses/by/4.0/)Tissue simulants are typically used in ballistic testing as substitutes for biological tissues. Many simulants have been used, with gelatine amongst the most common. While two concentrations of gelatine (10 and 20 %) have been used extensively, no agreed standard exists for the preparation of either. Comparison of ballistic damage produced in both concentrations is lacking. The damage produced in gelatine is also questioned, with regards to what it would mean for specific areas of living tissue. The aim of the work discussed in this paper was to consider how damage caused by selected pistol and rifle ammunition varied in different simulants. Damage to gelatine blocks 10 and 20 % in concentration were tested with 9 mm Luger (9 × 19 full metal jacket; FMJ) rounds, while damage produced by .223 Remington (5.56 × 45 Federal Premium® Tactical® Bonded®) rounds to porcine thorax sections (skin, underlying tissue, ribs, lungs, ribs, underlying tissue, skin; backed by a block of 10 % gelatine) were compared to 10 and 20 % gelatine blocks. Results from the .223 Remington rifle round, which is one that typically expands on impact, revealed depths of penetration in the thorax arrangement were significantly different to 20 % gelatine, but not 10 % gelatine. The level of damage produced in the simulated thoraxes was smaller in scale to that witnessed in both gelatine concentrations,though greater debris was produced in the thoraxes.The support of EPSRC and The Home Office are recognised

Wounding patterns and human performance in knife attacks: optimising the protection provided by knife-resistant body armour

Stab attacks generate high loads,1 and to defeat them, armour needs to be of a certain thickness and stiffness.2,3 Slash attacks produce much lower loads and armour designed to defeat them can be far lighter and more flexible.Methods and subjects: Phase 1: Human performance in slash attacks: 87 randomly selected students at the Royal Military College of Science were asked to make one slash attack with an instrumented blade on a vertically mounted target. No instructions on how to slash the target were given. The direction, contact forces and velocity of each attack were recorded. Phase 2: Clinical experience with edged weapon attacks: The location and severity of all penetrating injuries in patients attending the Glasgow Royal Infirmary between 1993 and 1996 were charted on anatomical figures.Results Phase 1: Two types of human slash behaviour were evident: a ‘chop and drag’ blow and a ‘sweep motion’ type of attack. ‘Chop and drag’ attacks had higher peak forces and velocities than sweep attacks. Shoulder to waist blows (diagonal) accounted for 82% of attacks, 71% of attackers used a long diagonal slash with an average cut length of 34 cm and 11% used short diagonal attacks with an average cut length of 25 cm. Only 18% of attackers slashed across the body (short horizontal); the average measured cut length of this type was 28 cm. The maximum peak force for the total sample population was 212 N; the maximum velocity was 14.88 m s−1. The 95 percentile force for the total sample population was 181 N and the velocity was 9.89 m s−1. Phase 2: 431 of the 500 patients had been wounded with edged weapons. The average number of wounds sustained by victims in knife assaults was 2.4. The distribution of wounds by frequency and severity are presented.Conclusions Anti-slash protection is required for the arms, neck, shoulders, and thighs. The clinical experience of knife-attack victims provides information on the relative vulnerabilities of different regions of the body. It is anticipated that designing a tunic-type of Police uniform that is inherently stab and slash resistant will eventually replace the current obvious and often bulky extra protective vest. Attempts at making a combined garment will need to be guided by ergonomic considerations and field testing. A similar anatomical regional risk model might also be appropriate in the design of anti-ballistic armour and combined anti-ballistic and knife-resistant armour

Probing fundamental physics with pulsars

Pulsars provide a wealth of information about General Relativity, the equation of state of superdense matter, relativistic particle acceleration in high magnetic fields, the Galaxy's interstellar medium and magnetic field, stellar and binary evolution, celestial mechanics, planetary physics and even cosmology. The wide variety of physical applications currently being investigated through studies of radio pulsars rely on: (i) finding interesting objects to study via large-scale and targeted surveys; (ii) high-precision timing measurements which exploit their remarkable clock-like stability. We review current surveys and the principles of pulsar timing and highlight progress made in the rotating radio transients, intermittent pulsars, tests of relativity, understanding pulsar evolution, measuring neutron star masses and the pulsar timing array.Comment: 6 pages, 1 figure, to appear in the proceedings of IAU XXVII GA - JD3 - Neutron Stars: Timing in Extreme Environments XXVII IAU General Assembly, Rio de Janeiro, Brazil, 3-14 August 200

Opportunities for weed manipulation using GMHT row crops

The herbicides and cultivation systems available in most non-GM crops allow farmers little flexibility as to when they control weeds. However, glyphosate and glufosinate-ammonium, as used in GM herbicide tolerant crops, offer the opportunity to control large weeds and weed control can be timed according to the agronomic and environmental aims of the user. This paper will use sugar beet as a model crop and report results where different approaches to weed control have been used and discuss their relevance in the wider agricultural and environmental contextNon peer reviewe

The Evaluation of Organizational Structure in the Rape Crisis Movement in Minnesota from 1970-1990

This study documents the changes in the organizational structure of the rape crisis centers (RCC) in Minnesota. It compares the organizational types of similar alternative agencies with those organizational types that emerged in RCC. It considers a framework that predicts at what period in the natural history of a social movement changes in organizational structure and personnel occur. It determines how the evolution of RCC reflects this framework. Finally, it assesses the relationship between feminist ideology and organizational functioning. Several findings emerge from this study. Over time, RCC evolved from grassroot collectives into programs of the Minnesota Department of Corrections. Many RCC have retained remnants of their feminist ideology in their structure. RCC accomplished many of their goals in terms of services to victims, legislative revisions, and public awareness. However, RCC failed to accomplish their original goal of changing the sexist society that fostered such sexual violence and aggression

[Review of] Ronald Takaki, ed. From Different Shores: Perspectives on Race and Ethnicity in America

From Different Shores is surely a very welcome addition to the growing body of research and serious study of ethnicity in America. Ronald Takaki has marshalled the expertise and scholarship of the more well-known scholars in the field and has produced a book which should be useful to serious students of ethnic studies